Ausgefallene für Ihre inspiration und informationszwecken bezüglich der erhebung Aukru HC-05 Wireless-Bluetooth-Host Serial-Transceiver-Modul Slave und Master RS232 mit 6 set kabel für Arduino exklusive updates. Sie können detailinformationen zu diesem produkt unten lesen.
Beschreibung:
the module parameters:
1.PCB Dimensions: 37.3mm (length) * 15.5mm (W)
2. Weight: 3.5g
3. Input voltage: 3.6V – 6V, 7V prohibit over
4. Power anti-reverse, reverse module does not work
5. leads to 6 pin: EN / VCC / GND / RXD / TXD / STATE (Bluetooth status leads to the foot, is not connected to the output low, output high after the connection)
6. En status indicator, LED flash means no Bluetooth connection; LED slow flash indicates into the AT command mode
7. On-board 3.3V regulator chip, the input voltage DC 3.6V-6V; when unpaired, current is about 30mA (because LED lights flashing, the current state of change); After the pairing is successful, the current is about 10mA
8. Level interface 3.3V, you can directly connect a variety of microcontroller (Arduino / 51 / AVR / PIC / ARM / MSP430, etc.), 5V microcontroller can also be directly connected. Directly connected to the microcontroller serial port, you can not go through MAX232 chip!
9. The open area effective transmission distance of 10 meters, over 10 meters are possible, but do not guarantee the quality of the connection
10. After the pairing is successful, can be used as a full-duplex serial interfaces. Do not need to know any of the Bluetooth protocol, but only supports 8 data bits, 1 stop bit, no parity communication format. This is the most common communication format, not support other format!
11. Press the button to give the Bluetooth module is powered up can enter AT mode, set parameters and query information
12. You can switch between master and slave mode via AT commands
13. The module default baud rate is 9600, the default passkey is 1234, the default name for the HC-05
14. protection with transparent heat shrinkable tube
Package 1*bluetooth module,
6 set kable
Funktionen:
- Bluetooth-Modul HC-05 Master-und Slave-Zwei in einem Modul Verwenden Sie die CSR-Mainstream-Bluetooth-Chip, Bluetooth V2.0 Protokoll-Standards Modul Arbeitsspannung 3,3 V
- 1. Working current: matching for 30 MA, matching the communication for 8 MA 2. Dormancy current: non dormancy
- 3. Used for GPS navigation system, water and electricity gas meter reading system 4. With computer and bluetooth bluetooth adapter, PDA, seamless connection equipment .pay your attention on this : Please do not connect the power supply with the signal pin directly,or it will result in broken
- mit Computer und Bluetooth Bluetooth-Adapter, PDA, nahtlosen Verbindungstechnik.
- Hinweis: Diese ist nicht original Arduino product.it ist nur ein Ersatz-Zubehör aus aukru.
Danke fürs Lesen Aukru HC-05 Wireless-Bluetooth-Host Serial-Transceiver-Modul Slave und Master RS232 mit 6 set kabel für Arduino.
